Edelbrock Torker II Intake Manifold 351W

The Torker intake can be used in conjunction with a range of camshafts.  The Torker intake is a good choice where increased performance is required but requiring a low installed height.  Initial throttle response would not be as good as Performer or Performer RPM intakes but a higher rpm power gain can be achieved over stock or Performer intakes.  Designed for street 1969 and later 351 Windsor small-block Ford.  Will accept OEM 4-bbl or Edelbrock Performer series carb.  Will not fit Boss 351Cleveland.  Recommended carb EDEL1405 for most mild applications.  Manifold height A-3.55”, B-4.75”.  Use intake bolt set EDEL8584

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Captcha